Operating Manual
KE7200 / KE7100
4
KURTH ELECTRONIC FERNMELDETECHNIK
www.kurthelectronic.de sales@kurthelectronic.de
Safety Instructions
The KE7200 / KE7100 may only be operated with the accessories
originally provided. Using the device with accessories that are not original
or for applications for which it was not intended can lead to incorrect test
results and may damage the device.
The relevant safety regulations in VDE 0100, 0800 and 0805 must be
observed.
The use of cables other than those provided can damage the
device. The device should not be connected to high voltage
sources such as AC power circuits. Kurth Electronic assumes no
liability for damage resulting from improper use.
Never open the device. There are no parts in the device that need
to be serviced or calibrated. To change the battery, open the
battery compartment. See the instructions in Appendix A.
The tester is protected from splashing water and dust by the front
covering. It is not water-tight, however.
Never pull unnecessarily on the device’s cables. To hang it up, use
the eyelet in the device and the provided strap.
For end-to-end cable testing, only use the KE7010 test remote that
was supplied or which can be ordered.
To Next Page
Loading...