Connecting to Your Audio System
The Audio Jacks (A & B Audio Outputs)
GS-8
The Audio Jacks (A & B Audio Outputs)
Please refer to “Connecting to Your Audio System” below.
The Headphones Jack
Use the Headphones jack to listen to the Forte on stereo headphones. On the Forte the
headphone jack is located at the front left of the instrument, under the Pitch & Modulation
wheels. On the Forte7 it is on the left end of the instrument, on the rear panel.
You will need a 1/4-inch-to-1/8-inch adapter in order to use headphones that have a smaller
mini plug connector.
Connecting to Your Audio System
After you’ve turned down the level on your sound system, connect the Forte analog audio
outputs to your sound system using a pair of balanced (TRS or “stereo”) or unbalanced (TS or
“mono”) audio cables. Unbalanced cables will always work, but if you’re going into balanced
inputs, use balanced cables for a better signal-to-noise ratio and a bit more volume. e Forte
analog outputs are balanced.
You’ll nd four 1/4-inch balanced audio output jacks on the rear panel, the “A” Audio Output
pair and the “B” Output pair. Connect one end of each audio cable to your mixing board or PA
system inputs, and connect the other end to the “A” Audio Output jacks marked Left (Mono)
and Right on the rear panel of the Forte. If you have only one input available, use the Forte’s
Left (Mono) output to get the full signal in mono. Use the jack marked Headphones (located
on the front/left of the instrument) to listen to Forte on headphones. When headphones are
plugged in, sound still comes through the Left and Right audio jacks.
Forte connected to powered speakers and headphones
“A” AUDIO OUTPUTS
NOTE: Headphone jack on the
Forte7 is on the rear panel
To Next Page
Loading...
