Sampling and Sample Editing
Editing Samples
15-23
End positions as the Start (S) and End (E) points (as set on the TRIM or LOOP page). In fact,
you can go to either of these pages to readjust the S and E points if you want to include more of
the sample. To save the new S and E points, press the Done soft button (if necessary) to return
to the Sample mode page, then press either the Save soft button, or EXIT.
3 Volume Adjust
Use this function for a uniform cut or boost in the amplitude of the selected sample segment.
This function will clip samples if you adjust the volume too high. This won’t hurt the K2500,
and you may find it useful in some applications. In any case, you’ll need to choose your start
and end points carefully, if you want to avoid abrupt changes in volume.
When you’ve selected the range to be adjusted, select the VolAdjust parameter with the cursor
buttons, and use the Alpha Wheel to adjust the volume of the selected range. You can cut/boost
the volume from -96 to 96 dB.
4 Clear
The result of this function is like erasing a section of recording tape. Use it to create sections of
silence without changing the overall length of the sample. If you want to completely remove a
segment and shorten the sample, you can do it with the Delete function.
F:VolAdjust||Start:1.019||||End:5.126|||
VolAdj:0dB||||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
F:Clear||||||Start:0.000||||End:6.000|||
||||||||||||||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
To Next Page
Loading...
