Sampling and Sample Editing
Editing Samples
14-31
parameter to 4, then Sample 2 will play on the Þrst, Þfth, and ninth beat of your six-second
Sample 1 segment. The result will look something like the diagram below.
If you change Beat to 3, Sample 2 will play on beats 3, 7, and 11. If you set Beat to 1 and Of to 6,
Sample 2 will play on beats 1 and 7. If you set Beat to -1, Sample 2 will still play on beats 1 and 7,
but the sound of the sample will change each time, as the start point of the Sample 2 segment
moves forward (later) by one beat each time it is mixed in.
Mix Beat (as well as Replicate and Mix Echo) may seem a bit complicated at Þrst, but if you
experiment with different settingsÑespecially for Beat and OfÑyouÕll quickly begin to get a feel
for what these functions do.
17 Replicate
With the exception of two differences, the replicate function is similar to the Mix Beat function.
The primary difference is that the replicate function uses the selected Sample 2 segment to
overwrite (replace) the selected Sample 1 segment, instead of merging the two segments like the
Mix Beat function. This makes it run faster. The other difference is that there is a crossfade
parameter instead of a Volume Adjust parameter. The crossfade parameter lets you smooth the
transition points from Sample 1 to Sample 2.
F:MixBeat||||Start:0.000||||End:6.000|||
Tempo:120|Beat:1||Of:4||VolAdj:0dB||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
F:Replicate||Start:0.000||||End:6.000|||
Tempo:120|Beat:1||Of:1||Xfade:0.000|||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
To Next Page
Loading...
Need help?
General
