Triple Modular Processing
Alphanumeric Buttonpad Entries for DSP Functions
2-39
Alphanumeric Buttonpad Entries for DSP Functions
The tables on the following pages list the entries that you can use on the K2600’s alphanumeric
buttonpad to select DSP functions without having to scroll through a long list of values. Table 2-
3 is sorted alphabetically by the name of the DSP function, and
When you’re on the ALG page, use the cursor buttons to select the DSP block whose function
you want to change, then type the numeric value corresponding to the function you want to
select. Press Enter after typing the value. For example, to select a DSP function of None in a
single-block function, type 6, 0, Enter.
Special Cases
In some algorithms, there are nonstandard DSP blocks containing specialized functions. These
functions have different numeric entries, as listed below. In all other cases, numeric entries select
DSP functions as listed in Table 2-3 and Table 2-4.
738 H.Sync Rhythm
MWheel Clocked pitch effect depth
Data Lowpass frequency
MIDI22 Lowpass2 freq / Parametric EQ frequency
MIDI23 Lowpass2 Gain / Shaper Amount
MIDI24 Crossfade master / slave
MIDI25 Stereo delay level
MIDI26 Stereo delay feedback
MIDI27 Chorus depth
MIDI28 Chorus feedback
MIDI29 Switch to alternative program
Algorithm and DSP Block Numeric Entry DSP Function
F1 in Algorithm 126
105 xAMP
106 +AMP
107 !AMP
F2 in Algorithms 123 and 124
108 LP2RES
109 SHAPE2
110 BAND2
111 NOTCH2
112 LOPAS2
113 HIPAS2
114 LPGATE
Program ID Program Name MIDI Controller Assignment
Table 2-2 Controller assignments for v2 factory triple programs
To Next Page
Loading...
