Kurzweil K2600 - Special Button Functions; Assignable Controllers; Psw1, Psw2 (Buttons 9 and 10); Record, Play;Pause, Stop

1-6
Front Panel
Special Button Functions
Assignable Controllers (Buttons 1–8 and Sliders A–H)
The function of these controllers will depend on how theyÕve been deÞned within a setup.
Buttons 1Ð8 control either zone muting or KB3 features, depending on the value of the value of
the Mutes parameter on the COMMON page in the Setup Editor. The SLIDER and SLID/2 pages
conÞgure the functions of Sliders AÐH.
PSw1, PSw2 (Buttons 9 and 10)
The function of these controllers depends on how theyÕve been deÞned on the SWITCH page in
the Setup Editor.
Record, Play/Pause, Stop
These buttons duplicate the functions of the corresponding soft buttons in Song mode, allowing
you to conveniently record, play, pause, and stop the current song.
Special Button Functions
The Mode buttons and the Chan/Bank Down button have additional functions, depending on
the mode or editor youÕre in. When youÕre in the Program or Setup Editor, they function
according to the blue labeling under each button. They also work as track mutes on the MIX
page of Song mode.
When youÕre in the Sample Editor, the Program, Setup, Q Access, MIDI, Master, and Song
mode buttons function according to the orange labeling near each button. Table 1-2 describes all
of the special button functions. This table also appears as Table 5-1 on page 5-8 of the MusicianÕs
Guide.
Button Mode or Editor
White
Blue
Orange
Program Editor (Blue) Setup Editor (Blue) Song Mode
Sample Editor
(Orange)
Program
Mute 1
Zoom-
Mutes Layer 1 of current program, or
mutes current layer of current drum
program
Mutes Zone 1 of current
setup if 3 or fewer zones;
mutes current zone of
current setup if more than 3
zones
On MIX page,
mutes Track 1
or 9
On TRIM and LOOP
pages, decreases
horizontal dimension of
current sample in
display
Setup
Mute 2
Zoom+
Mutes Layer 2 of current program, or
solos current layer of current drum
program
Mutes Zone 2 of current
setup if 3 or fewer zones;
solos current zone of
current setup if more than 3
zones
On MIX page,
mutes Track 2
or 10
On TRIM and LOOP
pages, increases
horizontal dimension of
current sample in
display
Q Access
Mute 3
Samp / Sec
Mutes Layer 3 of current program, or
solos current layer of current drum
program
Mutes Zone 3 of current
setup if 3 or fewer zones;
solos current zone of
current setup if more than 3
zones
On MIX page,
mutes Track 3
or 11
Toggles between units
used to identify location
within sample— either
number of samples from
start, or time in seconds
from start
Effects
FX Bypass
Bypasses (mutes) current program’s FX
preset (plays program dry)
Bypasses (mutes) current
setup’s studio (plays studio
dry)
On MIX page,
mutes Track 4
or 12
Table 1-2 Special Button Functions