Setup Mode and the Setup Editor
Controllers
7-23
Switch Controllers
Keyboard Controllers
Figure 7-2 Setup-mode Controllers
After youÕve selected which zone and which physical controller to work with, use the
Destination parameter to choose what this controller will do. Some of the controllers have
default settings that are preprogrammed in all of the factory setups (of course, you can change
them). You can select from the entire list of numbered MIDI controllers, as well as other MIDI
commands and some Òspecial functions.Ó To move through the list, you can use the Alpha
wheel, or Intuitive Entry with any continuous controller, or call up the ControllerÕs number with
the numeric buttonpad.
Physical Controller
Setup Editor
Page
Parameter:Values
Footswitches 1, 2, 3, and 4 FOOTSW SwType: Toggle, Momentary, Note Toggle, Note
Momentary
Destination: MIDI Control Source list
On Value: None, 0 - 127
Off Value: None, 0 - 127
Entry Value: None, Off, On
Exit Value: None, Off, On
Panel Switches 1 and 2 SWITCH (same as Footswitches)
Table 7-4 Switch Controllers
Footswitch Pedals
Pitch Wheel
Mod Wheel
Small Ribbon
Large Ribbon
Panel
Programmable Sliders
Continuous
Breath Controller
Control Pedals
Switches
To Next Page
Loading...
