7-48
Setup Mode and the Setup Editor
Editing Hints and Suggestions
equal to 64, and <64 means less than 64. >0 means you can use any value thatÕs greater than 
zero. x means you can use any value.
Do I Need All Those Pedals?
ItÕs important to realize that you donÕt have to have an actual pedal plugged into every Pedal 
and Switch Pedal jack in order to take advantage of all of them. Entry and exit values can be 
assigned to a zone and to a physical controllerÕs destination even if the controller isnÕt there, and 
they will behave as if the controller were in fact plugged in. So if you want a speciÞc group of 
Controller commands to be sent out whenever you choose a setup, and you know theyÕre not 
going to change while youÕre playing, you can assign them as the destinations of physical 
controllers that arenÕt in use.
Multiple Controllers
Sometimes youÕll want to assign the same Controller number as the destination of more than 
one physical controller. For example, you might want to be able to control modulation depth 
both with Wheel 2 and with pressure. The K2600 has no restrictions on assigning multiple 
physical controllers to a particular MIDI Controller.
Editing Programs
Remember, except for control-setup parameters, everything you deÞne in a setup affects 
programs only while you are in Setup mode. To edit the programs themselves while you are in the 
Setup Editor, go to the CH/PRG page and press Edit. This gives you access to the other editors 
nested within the Program Editor as well. When you have Þnished editing your program, press 
Exit to save it and return to the Setup Editor.
MIDI 
Controller 
Number
MIDI Controller On Value Off Value
102 Play/Stop >=64 <64
103 Record/Stop >=64 <64
120 All Sound Off >=64 <64
121 Reset All Controllers >=64 <64
122 Local Control Off >=64 <64
123 All Notes Off >=64 <64
124 Omni mode Off >=64 <64
125 Omni mode On >=64 <64
126 Mono mode On (the On value, in some synths, 
specifies the number of MIDI channels to 
respond to, with one voice on each)
>=64 <64
127 127 Poly mode On >0 x
Table 7-6 Little-used MIDI Control Sources