7-50
Setup Mode
The Setup Editor
Arpeggiator Sync (ArpSync)
Setting ArpSync to Sync Mode allows you to arpeggiate across zones boundaries. There are two
important points to keep in mind when using Sync Mode:
• Make sure that the ARPEGGIATOR keyranges of each zone that you want to sync cover the
entire keyboard, rather than covering the range of the current zone. If the ARPEGGIATOR
keyranges do not coincide, then playing keys in separate zones will sound no different from
having ArpSync set to Not in Sync.
• For “regular” arpeggios, make sure the Beats parameter settings on the ARPEGGIATOR page
of each zone that you want to sync are the same. Different Beats values result in irregular—
but potentially very interesting—arpeggios.
Aux FX Channel
The Aux FX Channel determines the FX channel through which the aux sends of all of the zones
in the current setup are sent. For example, if a zone 2 in a setup has a program with 25 Basic
Delay 1/8 as an Aux FX, and zone 2 is assigned to channel 5, then setting the Aux FX Channel to
5 sends the programs of all of the zones in the setup through zone 2’s Program’s Aux FX (i.e.,
through 25 Basic Delay 1/8).
KB3 Channel
With this parameter, you can specify the KB3 channel in the current setup (because KB3
programs can play on only one channel/zone at a time, See page 6-5 for more information on
KB3 mode.)
To Next Page
Loading...
