13-30
Tutorials: Setup Mode
Switch Between Zones Based On Played Keyboard Velocity
Switch Between Zones Based On Played Keyboard Velocity
You can set a setup Zone to only be heard when the keyboard is played within a certain velocity
range. This technique can be used in different ways depending on the situation. Here we will go
over one of its most basic uses. We will edit the setup 8 Piano & Pad. The setup 8 Piano & Pad is a
layered setup that uses piano on Zone 1 and “pad” type synth sounds on Zones 2 and 3. Lets edit this setup
so that the pad sounds on Zones 2 and 3 are only heard when the keyboard is played with a high velocity
(struck hard.) Using Zone velocity ranges in this way allows you to emphasize the dynamics of your
playing, by having more sounds come in as you play louder, and having sounds drop out when you play
more quietly.
1. If you are not already in Setup mode, press the Exit button until you reach the ProgramMode page,
then press the Setup mode button, located with the mode buttons to the left of the display. This
will bring you to the Setup mode main page. Next, press 8 and then Enter on the alphanumeric pad
to select the setup 8 Piano & Pad (see below.) You can also select setups by using the - / + buttons
or Alpha Wheel.
2. With the setup 8 Piano & Pad selected in setup mode, press the Edit button on the front panel.
This will bring you to the CH/PROG page of the setup editor (see below.)
3. From the CH/PROG page press the KEYVEL soft button (see above.) This will bring you to the
KEYVEL page for the current Zone.
Step 3
To Next Page
Loading...
