Setup Mode
The Control Setup
7-69
When editing the control setup, only zone 1 has an effect on program mode. (Zones 2–16 are not
relevant in Program Mode, because the PC3LE’s physical controllers can only control one MIDI
channel at a time in Program Mode. A control setup should have only 1 zone.) See the table
below for which pages and parameters in the Setup Editor of the Control Setup have an affect on
Programs in Program Mode.
Aside from assigning MIDI CC destinations for the PC3LE’s physical controllers, the Control
Setup allows you to set other available parameters for each physical controller, such as Scale,
Curve, and Offset, and Switch Type (see Controllers (CTRLS) Page on page 7-9.)
On the CH/PROG page of the Control Setup, you can set a MIDI Destination for the currently
selected channel in Program Mode, as well as the Bank Mode which determines how Program
Mode will send MIDI bank messages (see The Channel/Program (CH/PROG) Page on page 7-6.)
On the KEY/VEL page of the Control Setup, you can set parameters that determine the usable
key and velocity ranges, transposition, and velocity options, though these are best left at their
defaults. For program mode, it is best to set transposition settings with Xpose or Octav soft
buttons on the Program Mode main page (see The Program Mode Page on page 6-2.) An overall
velocity response adjustment is best made with the VelMap setting on the Master Mode 1 page
(see Velocity Map (Vel Map) (Master) on page 9-3.)
Control Setup:
Setup Mode: ID# 126: Internal Voices:
Setup Editor Zone 1
Page:
Parameters Affecting Program Mode
Controllers Page (CTRLS) All Parameters Except: Entry Value, Exit Value,
On Value, Off Value, All Parameters for Drum
Pad Pages
CH/PROG Destination, BankMode
KEY/VEL All
Control Setup Default Assignments
PC3LE Physical Controller Controllers Page Name (And
Front Panel Name)
Continuous Controller
Number And Name
Mod Wheel 1 (MWheel)
Pitchbend up 130 (PitchUp)
Pitchbend dn 131 (PitchDwn)
SW Pedal 1 64 (Sustain)
SW Pedal 2 66 (Sostenut)
CC Pedal 1 11 (Express)
Pressure 132 (Pressure)
Arp. Switch (Arp Enable) 147 (ArpOn,) 148 (ArpOff)
Arp. latch sw (Arp Latch) 157 (Latch)
Knob 1 (Timbre,) Knob 2 (Mod) 14-15 (MIDI14-15)
Knob 3 (Envelope,) Knob 4 (Effect,) Knob 5 (Reverb,) Knob6 (CTL6) 16-19 (CtlA-D)
Knob 7-15 (CTL7-15) 20-28 (MIDI20-28)
Switch 1-4 (SW1-4) 80-83 (MIDI80-83)
Switch 5-10 (SW5-10) 85-90 (MIDI85-90)
To Next Page
Loading...
