Tutorials: Setup Mode
Using And Editing A Split Program Setup
13-5
Part 2: Changing The Split Point (Setting Zone Key Range)
You can use the Setup Editor to change the “split” point on the keyboard, the point where one
Zone stops and the other begins. For example, let’s change the split point of the setup 38 Jazz
Bass/Piano. 38 Jazz Bass/Piano has 2 Zones (which we will see upon entering the Setup Editor.)
Each Zone in a setup contains an instrument program. The programs in this setup are AC
Buzzer Bass and Grand "Evans". Let’s change the split point of this setup to happen an octave
higher. We will have an octave more of high bass notes and an octave less of low piano notes.
This is done by adjusting the key range for each Zone:
1. With the setup 38 Jazz Bass/Piano selected, press the Edit button on the front panel. This will
bring you to the CH/PROG page of the setup editor (see below.)
2. On the CH/PROG page use the Chan/Zone buttons to the left of the display to select Zone 1
(see above.) You can view the number of the selected Zone in the top right corner of screen. In the
Program field you can view the instrument Program for the current Zone. We can see that the
program for Zone 1 of this setup is 235 AC Buzzer Bass.
3. From the CH/PROG page, press the KEYVEL soft button on the bottom of the screen (see above.)
This brings you to the KEY-VEL page where you can view the key range for the current Zone. On
the KEY-VEL page we will adjust the key range for Zone 1. You can see that Zone 1 is still
selected, displayed in the top right corner of screen (see below.)
4. On the KEY-VEL page for Zone 1, use the cursor buttons to highlight the HiKey field. This field
sets the upper limit of the key range for Zone 1, which contains the bass program. Let’s make the
upper range of this Zone end an octave higher by changing the HiKey field from D#3 to D#4. To
do this, select the HiKey field, hold the Enter button on the alphanumeric pad and play D#4
Step 3
Step 2
To Next Page
Loading...
