13-16
Tutorials: Setup Mode
Assigning Multiple Knobs To Control Volume In Different Zones
10. With Knob 2 selected in the Controller field, use the cursor buttons to select the DestType field and
then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)
11. With Ctrl selected in the DestType field, use the cursor buttons to select the Dest field. In the Dest
field, press 7 and then the Enter button on the alphanumeric pad to choose Volume (see below.)
You can also use the Alpha Wheel or - / + buttons to select a destination in the Dest field.
Knob 2 (labeled Mod on the front panel) should now control the volume of the piano, which is
on the upper half of the keyboard (if not, review the previous steps.) All other settings on the
Controllers page for Zone 2, Knob 2, should be left at their default values.
12. To finish, press the Exit button to the right of the display to exit the Setup Editor and save your
changes to this setup under a new ID#. See The Setup Editor section at the beginning of this
chapter for details on saving when you exit the Setup Editor.
If you have a setup with more Zones, you can repeat the same steps for each additional Zone,
using additional Knobs.
To Next Page
Loading...
