Tutorials: Setup Mode
Assigning A Single Knob To Control Relative Volume In Different Zones
13-21
Scale Method
The Scale method multiplies the volume of one your Zones by a percentage. This means that the
scaled Zone’s volume will always be a certain percent different than the non scaled Zone. Unlike
the Offset method which always sets a specific value of volume difference, the Scale method
changes the volume difference between Zones for each new volume setting. Using a scale value
of more than %100 can result in values truncated to 127 if the result of scaling is greater than 127.
1. If you are not already in Setup mode, press the Exit button until you reach the ProgramMode page,
then press the Setup mode button, located with the mode buttons to the left of the display. This
will bring you to the Setup mode main page. Next, press 8 and then Enter on the alphanumeric pad
to select the setup 8 Piano & Pad (see below.) You can also select setups by using the - / + buttons
or Alpha Wheel.
2. With the setup 8 Piano & Pad selected in setup mode, press the Edit button on the front panel.
This will bring you to the CH/PROG page of the setup editor (see below.)
3. From the CH/PROG page, press the CTRLS soft button on the bottom of the screen (see above.)
This brings you to the Controllers page where you can view and assign physical controllers to
destinations for the current Zone.
4. On the Controllers page, use the Chan/Zone buttons to the left of the display to select Zone 2 (see
below.) You can view the number of the selected Zone in the top right corner of screen.
Step 3
To Next Page
Loading...
