Tutorials: Setup Mode
Assigning A Single Knob To Control Relative Volume In Different Zones
13-23
the display to select Zone 3 (see below.) You can view the number of the selected Zone in the top
right corner of screen.
9. On the Controllers page for Zone 3, Knob 1 will still be selected in the Controller field. If not,
follow these steps: Use the cursor buttons to select the Controller field. Make sure the LED to the
left of the Timbre Knob is lit, if it is not, press the Shift button to the left of the Knobs until that
LED is lit. Next, hold the Enter button on the alphanumeric pad and move the Knob labeled
Timbre. This will select Knob 1 for the Controller field. You can also set the desired controller in
the Controller field by using the Alpha Wheel or - / + buttons.
10. With Knob 1 selected in the Controller field, use the cursor buttons to select the DestType field and
then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)
11. With Ctrl selected in the DestType field, use the cursor buttons to select the Dest field. In the Dest
field, press 7 and then the Enter button on the alphanumeric pad to choose Volume (see below.)
You can also use the Alpha Wheel or - / + buttons to select a destination in the Dest field.
To Next Page
Loading...
