13-28
Tutorials: Setup Mode
Assigning A Single Knob to Crossfade Between The Volume Of Different Zones
Timbre. This will select Knob 1 for the Controller field. You can also set the desired controller in
the Controller field by using the Alpha Wheel or - / + buttons.
11. With Knob 1 selected in the Controller field, use the cursor buttons to select the DestType field and
then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)
12. With Ctrl selected in the DestType field, use the cursor buttons to select the Dest field. In the Dest
field, press 7 and then the Enter button on the alphanumeric pad to choose Volume (see below.)
You can also use the Alpha Wheel or - / + buttons to select a destination in the Dest field.
13. Now we will set an Offset value for Zone 3. On the Controllers page for Knob 1, Zone 3, use the
cursor buttons to select the Offset field. On the alphanumeric pad press 127, then the Enter button
to enter 127 as an offset value (see below.)
To Next Page
Loading...
