Kurzweil PC88 - Page 39

Chapter 3 Disassembly/Assembly
Assembly Instructions
When removing ribbon cable connectors, it has been
noted throughout the Disassembly instructions to peel
back clear adhesive tape securing the ribbon cable
connectors. Please note that when following Assembly
instructions, you should only use ribbon cable connector
locking clips to secure the connectors.
If these are not available to you, they may be obtained
through the Young Chang America Kurzweil Service
Department. International servicers should contact their
appropriate Young Chang/Kurzweil Distributor.
PC88 Service Manual
3-3