Kurzweil PC88 - Page 46

Chapter 3 Disassembly/Assembly
EMI Shields
Removing the I/O Board
It is not necessary to remove any EMI Shield to
remove the I/O Board only.
On the I/O Board, disconnect the following cables from
locations: J302, J318, J301 and J306.
Remove the 10 Phillips head screws that secure the I/O
Board to the rear panel. This includes the screw securing
the "T" shaped strain relief used to protect the AC adaptor
cable.
The I/O Board can now be removed.
You will notice the 1/O Board is attached to its
mounting bracket. It is not necessary to remove the board
from the mounting bracket unless a repair requires you to
do so.
If the repair requires you to remove a 1/4 inch jack for
replacement, you need to remove the hardware securing
all 1/4 inch jacks.
Should you need to remove the MIDI jacks, you will
need to desolder the MIDI jacks bracket.
PC88 Service Manual
3-10