Kurzweil PC88 - Page 51

Chapter 3 Disassembly/Assembly
EMI Shields
Removing the Slider Board
Remove the Phillips head screws that secure EMI
Shield No. 2. Refer to Figure 3.2. Remove the shield.
Clip the tie wraps used to bundle the cables together.
Carefully lift the Slider Board back towards the rear
panel.
Disconnect the shielded wire cable at location J102 on
the Slider Board.
Disconnect the shielded wire cable from location J12 on
the Engine Board.
The Slider Board can now be removed. Note: It is not
necessary to remove the slider caps from the front panel
side.
Replacing the Slider Board
Connect the shielded wire cable to location J102 on the
Slider Board. The connector is keyed and cannot be
installed backwards.
Place the Slider Board into position.
Connect the shielded wire cable to location J12 on the
Engine Board. The connector is keyed and Pin 1 is noted
on the board.
Add tie wraps to bundle the cables together. Be certain
that you have left some slack on the cables. When the tie
wraps are in place, be sure that all cables are still secure to
their respective connectors.
Place the shield in position. Install the Phillips head
screws that secure EMI Shield No. 2. Refer to Figure 3.2.
PC88 Service Manual
3-15