Kurzweil PC88 - Page 52

Chapter 3 Disassembly/Assembly
EMI Shields
Removing the Engine Board
Remove the Phillips head screws that secure EMI
Shield No. 1. Refer to Figure 3.2.
Remove the shield.
Disconnect the flat ribbon cables and wire cables at the
following locations: J11 (Panel), J15 (Backlite), J12 (Slider),
J13 (Pedals), J9 (MIDI/Footswitch), J7 (LCD), J2 (Audio
Out), and J3 (Power).
The Engine Board can now be removed.
Replacing the Engine Board
Place the Engine Board in position.
Connect the flat ribbon cables and wire cables at the
following locations: J11 (Panel), J15 (Backlite), J12 (Slider),
J13 (Pedals), J9 (MIDI/Footswitch), J7 (LCD), J2 (Audio
Out), and J3 (Power). Be sure to secure the cable
connectors with locking clips.
Place the shield in position.
Install the Phillips head screws that secure EMI Shield
No. 1. Refer to Figure 3.2.
PC88 Service Manual
3-16