Kurzweil PC88 - Page 68

Chapter 3 Disassembly/Assembly
Removing the Wheel Assembly
This procedure assumes that the PC88 has been opened
and that the Top Cover Assembly has been set safely aside.
Tilt the bottom of the unit up and remove the 2 screws
closest to the rear panel that secure the Mod Wheel
Assembly to the bottom chassis.
Place the unit back flat on the work area and slide the
left side of the unit out over the edge of the work area so
that you can remove the 2 screws closest to the front that
secure the Mod Wheel Assembly to the bottom chassis.
Slide the unit back completely onto the work area.
Slowly lift the Mod Wheel Assembly and disconnect
the keyboard pressure strip cables from the Mod Wheel
Assembly. Disconnect the front (natural/white keys)
pressure strip cable from J202 on the Mod Wheel
Assembly and the pressure strip from the back
(sharp/black keys) from J203 on the Mod Wheel
Assembly.
It is not necessary to disconnect the cable at J201 on the
Mod Wheel Assembly.
PC88 Service Manual
3-32