Kurzweil PC88 - Page 69

Chapter 3 Disassembly/Assembly
Removing the Keyboard
This procedure assumes that the PC88 has been opened
and that the Top Cover Assembly has been set safely aside.
Remove the Mod Wheel Assembly prior to removing
the keyboard.
Refer to the following illustration. Note the positions
of the keyboard mounting screws located towards the rear
of the unit. These positions differ slightly in the PC88.
Therefore, the quantity of screws to remove differs.
Earlier units had 3 screws securing the rear of the
keyboard. The latest PC88s, including the PC88MX, have 5
and should match the illustration. Remove the screws
labelled A.
Figure 3.12
Enclosure Support Wall Screw Locations
Rear Panel
Keyboard
Tilt the bottom chassis up and remove the Phillips
head screws located closest to the rear panel.
PC88 Service Manual
3-33