Kurzweil PC88 - Page 70

Chapter 3 Disassembly/Assembly
Place the unit back flat on the work area and slide the
front edge out over the edge of the work area so that you
can remove the 5 screws that secure the front edge of the
keyboard to the chassis.
Slide the unit back completely onto the work area.
You will notice that the Bass and Treble ribbon cables
coming from the underside of the keyboard are taped to
the bottom chassis. Simply pull back the tape to free the
cable. You should lay the tape flat against the bottom so
that it can be reapplied to the cables once the keyboard is
re-installed.
The keyboard can now be completely removed from
the bottom chassis.
PC88 Service Manual
3-34