Kurzweil PC88 - Page 71

Chapter 3 Disassembly/Assembly
Removing a Key
This procedure assumes that the PC88 has been opened
and that the Top Cover Assembly has been set safely aside.
Follow the instructions indicated to remove the screws
securing the keyboard to the chassis.
It is not necessary to remove the keyboard from the
chassis. Once the screws securing the keyboard to the
chassis have been removed, simply slide the keyboard
back towards the rear about a 1/2 inch.
Figure 3.13
Natural | White Key
Spring
—>>
Strikes the key contacts f jen \
Mounts through the
on key depression.
keyboard chassis. Rests up against the
keyboard chassis
This hooks under the front
of the keyboard chassis
Sharp | Black Key
Pivot
Strikes the key contacts Rests up against the |
on key depression. keyboard chassis
This hooks under the front
of the keyboard chassis
PC88 Service Manual
3-35