Kurzweil PC88 - Page 72

Chapter 3 Disassembly/Assembly
NaturallWhite Keys
Remove the silver key spring (located at the rear of the
key). You will notice that the bottom of the spring is
secured to the chassis by a hook. Using needle-nose pliers,
unhook the spring by pulling the spring down slightly
and releasing it from the hook.
Notice the plastic pivot piece coming through the top
of the key.
To remove the key, insert a small flat screwdriver at
the bottom of the pivot and press towards the front edge
of the keyboard. While doing so, lift the back end of the
key (where spring was positioned). This frees the key.
Remove the screwdriver.
Lift the key up slightly, then forward. You should be
able to feel when the key is completely free. The front
edge of each key hooks under the keyboard chassis. Be
sure the the hooks are free prior to lifting the key
completely off.
Sharp/Black Keys
Follow the instructions indicated to remove the
keyboard.
Prior to removing a sharp key, it is necessary to
remove adjacent natural keys.
Remove the gold key spring (located at the rear of the
key). You will notice that the bottom of the spring is
secured to the chassis by a hook. Using needle-nose pliers,
unhook the spring by pulling the spring down slightly
and releasing it from the hook.
Notice the plastic pivot piece coming through the top
of the key.
PC88 Service Manual
3 - 36