Kurzweil PC88 - Page 73

Chapter 3 Disassembly/Assembly
To remove the key, insert a small flat screwdriver at
the bottom of the pivot and press towards the front edge
of the keyboard. While doing so, lift the back end of the
key (where spring was positioned). This frees the key.
Remove the screwdriver.
Lift the key up slightly, then forward. You should be
able to feel when the key is completely free. The front
edge of each key hooks under the keyboard chassis. Be
sure the the hooks are free prior to lifting the key
completely off.
Replacing a Key
Place the key into position by hooking the front end of
the key into the front edge of the keyboard chassis. Check
that the mounting peg is correctly positioned.
Move the key down into a horizontal position. You
should see the pivot lining up with the hole at the rear of
the key.
At this point, the key should just snap into position.
Install the key spring.
PC88 Service Manual
3 - 37