Kurzweil PC88 - Page 76

Chapter 3 Disassembly/Assembly
Removing the Keyboard Contact Strips
This procedure assumes that the PC88 has been opened
and that the Top Cover Assembly has been set safely aside.
Follow the instructions indicated to remove the
Keyboard and the Keyboard Contact Boards from the
chassis.
Remove a contact strip, by gently lifting and freeing the
strip from its position. Be careful not to rip or damage any
contacts in the process.
Before you remove a contact strip, look at the design of
the individual contact. Notice that the top of the contact
has two indents and the deeper indent is located to the
rear of the key.
Figure 3.14
Partial view of back end of a
NaturallWhite Key
Pivot
< Strikes Key
Contacts
___Key Contacts
Side View
P.C. Board
Mounting Pegs —— A
° °°
Key Contacts ‘
Deeper Contact to back
PC88 Service Manual
3-40