Kurzweil PC88 - Page 78

Chapter 3 Disassembly/Assembly
After the keys have been removed, inspect the rod.
There are two styles of rod support brackets. Some
keyboards have rod support brackets with a locking clip
attached to the top of the rod support bracket and others
do not. You will need to determine this before proceeding
further.
The following procedures describe removing key
weights from both styles of keyboards. Follow the
instructions and illustration labelled "A" for keyboard
without locking clips and follow the instructions and
illustration labelled "B" for keyboards with locking clips.
Figure 3.15
Side View of Support Brackets
“A a3 “B”’
Locking Clip
Key Weight Key Weight i
‘Ne Rod “Ne Rod
Support <q——__ Support
Bracket Bracket
A. If you are removing a key weight from a keyboard
that does not have rod support locking clips, you
will need to pry the rod up out of the support
bracket at one end. Be aware that the key weights
will stay attached to the rod.
Once the rod is released, you can simply pull off
the key weight that needs to be replaced.
PC88 Service Manual
3-42