32
Loading PCR-1 Files Into RAM
see in the display doesn’t match the version number on the
file you installed, the file didn’t get installed properly.
Try installing the file again. Watch the display carefully to
make sure the instrument is receiving data from the
sequencer. make sure that you see Done in the display before
stopping the playback of the file.
If you downloaded or copied any of the files, one or more of
them may be corrupted. Try downloading the files again. The
address for the Kurzweil website is on page ii.
If you’re still having problems, consult a Kurzweil dealer or
service center.
Loading PCR-1 Files Into RAM
The set of programs you’re going to use most—Orchestral or
GM—is the set you should install in ROM. That way the
programs/setups will always be available, even if you do a
hard reset.
Whichever set you decide to install in ROM, you can still
have access to the other set of programs, by loading them
into RAM. This set of programs stays in RAM until you load
something else into RAM or do a hard reset.
Caution: Loading files into RAM replaces some or all of the
objects already stored there. When you load the GM set into
RAM, it replaces all the programs in the User bank. When
you load the Orchestral set, it replaces all the programs in the
User bank, as well as Setups 001–032 in the User bank. If you
don’t want to lose these programs and setups, you should
dump (save) them before loading See your instrument’s
User’s Guide for instructions.
1. Connect a MIDI cable from the MIDI Out of your
computer or sequencer to the MIDI In of the PC2.
2. Insert the PC2 CD into the CD-ROM drive of your
computer or sequencer.
3. Launch your sequencer application if necessary.
To Next Page
Loading...