Updating Software
31
Verifying the Software Installation
This procedure assumes that you’ve properly installed the
hardware portion of the PCR-1 option, verified the
installation (as described on page 16 for keyboard models or
page 25 for rack-mount models), executed a hard reset, and
returned to a performance mode.
1. Press the Global button to enter the menu of global
parameters.
2. Press the Right cursor button repeatedly until you see
the parameter named OS Version. The version number
in the display should match the version number in the
name of the operating system file you installed (the
version must be 3.0 or later for the PCR-1 option to
work; 4.0 or later for the PCR-2 option).
See the troubleshooting section below if any of the steps in
the verification procedure gave you the wrong result.
Troubleshooting for Software Updates
You’re not likely to have problems updating your software.
In fact, there are very few things that can go wrong:
Display is Stuck at Waiting for MIDI
The MIDI signal isn’t getting to the PC2. Make sure that the
computer or sequencer’s MIDI Out is connected to the PC2’s
MIDI In. Make sure the cable isn’t defective. Try another
cable if necessary.
Display Never Shows Done
It’s possible that the PC2 isn’t receiving all of the MIDI file
data. Try playing the MIDI file at a slower tempo.
It’s also possible that there’s an issue with your MIDI
interface. Installing the latest version of your interface’s USB
driver (available from the interface’s manufacturer) may
help. You might also try a different MIDI interface.
Version in Display Doesn’t Match Version of File
This applies to operating system software, basic soundware
objects, and program/setup files. If the version number you
To Next Page
Loading...