30
Updating Software
shows segment|1|of|x. When the display shows
Done, stop the sequencer if it doesn’t stop
automatically. As soon as you see Done, you can go on
to the next step.
7. If your instrument does not contain the PCX-1 option,
proceed to Step 8. If it does contain the PCX-1 option,
you need to update its operating system software as
well. Repeat Steps 4 through 6 above, but this time
install the file pc2pnnn.mid. When you’re finished,
proceed to Step 8.
8. Follow the instructions in the next subsection if you
need to update soundware data. If you don’t need to
update soundware, proceed to Doing a Hard Reset
(page 30).
Doing a Hard Reset
This procedure assumes that you’re in the boot block menu.
If you aren’t, relaunch the boot block (see page 27 if you need
a reminder), then proceed.
1. Press the Left or Right cursor button until you see
Hard|RESET in the bottom line of the display.
2. Press Yes. The display prompts you with a question:
Erase|RAM|objects?
3. Press the Right cursor button. This performs the hard
reset and returns you to the boot block menu.
4. Follow the instructions in Returning to Normal
Operations From the Boot Block Menu below.
Returning to Normal Operations From the Boot Block Menu
1. Press the Left or Right cursor button until you see
Run|engine in the bottom line of the display.
2. Press Yes. After a few seconds, you’ll be back in a
performance mode. You’re now ready to verify the
software installation.
To Next Page
Loading...