To Next PageTo Next Page
Need help?Do you have a question about the Kustom Signals ProLaser III and is the answer not in the manual?
General| Accuracy | +/- 1 mph (+/- 2 km/h) |
|---|---|
| Operating Temperature | -22°F to +140°F (-30°C to +60°C) |
| Laser Wavelength | 904 nm |
| Acquisition/Measurement Time | 0.3 seconds |
| Display | LCD |
| Beamwidth/Beam Divergence | 3 mrad |
| Type | Laser Speed Detection Device |
Provides an overview of the ProLaser III's advanced features and benefits.
Lists standard included items and available options upon receiving the ProLaser III.
Explains how the ProLaser III uses lidar for distance and speed measurement.
Details the function of each external control on the ProLaser III unit.
Explains Power, Trigger, and TEST/ENTER switch operations.
Covers BRT/VOL/ARROW, MODE/ARROW, and MENU/ESC switch functions.
Describes the LCD's role in displaying data, menus, alerts, and status.
Explains the HUD's role in aiming and displaying target speed/range.
Details information displayed on the HUD during operation and testing.
Details the 'Low Voltage Alert' and 'Low Voltage Warning' indicators.
Covers initial setup considerations and the importance of operator training.
Explains the cosine effect and its impact on speed measurement accuracy.
Discusses visibility, weather, glass, and stability for optimal operation.
Describes the self-test sequence and displayed messages upon power-up.
Covers accuracy tests and program memory verification.
Shows how the unit of measure (Feet/MPH or KM/H/M) is displayed.
Indicates the default mode and HUD display upon power-up.
Covers toggling between Speed/Range modes and menu navigation.
Details how to adjust HUD brightness and audio volume levels.
Allows turning the LCD backlight on or off for night operations.
How to set the minimum range for target speed display.
How to set the maximum range for target speed display.
Allows selection of approaching, receding, or both target directions.
Explains the 'Poor' weather mode to improve performance in adverse conditions.
Introduces the stopwatch feature for calculating average speed.
Guide for testing the instrument against an external standard.
Details a test for range measurements to known fixed distances.
Provides instructions for performing the DIF-TEST calibration.
Step-by-step guide for making speed measurements in Speed Mode.
Instructions for making range measurements in Range Mode.
Details how to use the stopwatch mode for average speed calculation.
Describes the I/O connector for connecting external devices.
Explains the unit's automatic 'sleep' mode and how to restore operation.
Details how to attach and use the battery handle and charging.
Provides instructions for proper battery disposal and recycling.
Instructions for cleaning the external optical surfaces to maintain performance.
Common-sense procedures for prolonging the instrument's useful life.
Steps to take when suspected instrument malfunction occurs.
Covers CDRH certification as Class I laser and general eye safety.
Recommends precautions for operating the ProLaser III safely.
Details FCC compliance and the device's classification as Class A digital.
Lists key general specifications like voltage, temperature, and dimensions.
Details operational parameters such as speed range, accuracy, and wavelength.
Outlines the terms and duration of the ProLaser III warranty.
Specifies conditions that void the warranty and limits liability.
Clarifies warranty for consumables and SMART Radar units.
