086A and 086AS CLOSER
TABLE OF CONTENTS
I SPECIFICATIONS.................................. 1.1 - 1.2
II OPERATION........................................... 2.1 - 2.2
III ADJUSTMENTS......................................3.1 - 3.8
IV TROUBLE SHOOTING............................4.1 - 4.3
V PARTS IDENTIFICATION....................... 5.1 - 5.8
VI WIRING........................................................6.1
APPENDIX................BAG LENGTH FORMULA
SUGGESTED SPARE PARTS
SECTION HEADING PAGE
GENERAL SAFETY INFORMATION
Be sure the following safety instructions are read, understood and become a part of daily
practice when operating or maintaining the closing head.
1. Do not attempt to operate the closer until you understand its function. Study the manual
carefully.
2. Keep all foreign material away from the drive system.
3. Keep fingers out of the closer and away from any moving parts.
4. Disconnect the power cord before making any adjustments or maintenance. All
moving parts must be completely stopped before continuing. All adjustments are made
with power disconnected.
5. The closer is normally operated from a counter or table. While the closer is very stable
when operated from a flat a solid surface, care should be taken not use it in a way that
could cause it to tip or fall from the operating surface.
® 2008 KWIK LOK CORPORATION
Kwik Lok and Striplok are trademarks of Kwik Lok Corporation ® 2008
The shape of the closure is a trademark of Kwik Lok Corporation ®2008
086A 07 08
To Next Page
Loading...