Kwikee 888 - Step With Control Unit (Lock;Stationary Extended Mode); Step Without Control Unit

Rev: 08.04.2017
Page 6
Kwikee® 888 Electric Step Owner's Manual
Step With Control Unit (Lock/Stationary Extended Mode)
1. If your step is equipped with a step switch, and you would like the step to remain in the extended
position while the door is opened and closed, place the step switch in the position for the step to
extend when the door is opened and retracted when the door is closed (step assembly follows the
door). The step should remain in the extended position with the under step light off when the door is
closed.
2. With the step switch in the appropriate step lock position, the step extended, and the entrance door
closed, turn the vehicle ignition on. The ignition override system will go into effect and the step will
automatically retract.
NOTE: If the yellow wire from the 4-way connector is not connected to an ignition power source, the
ignition safety system will be inoperative and the step will remain in the extended position. In this
case, the step lock switch must be placed in the Automatic Mode position for the step to retract.
3. Turn the vehicle ignition off and open the door. The step will extend and lock in the DOWN position.
This is the "Auto Extend" feature. When the vehicle ignition is turned on, the step will always activate
with the door movement, regardless of the step switch position.
NOTE: If the yellow wire from the 4-way connector is not connected to an ignition power source, the
ignition will not cause the step to retract if the step lock switch is placed in the Automatic Mode
position, regardless of the door position.
Step Without Control Unit
1. To extend the step, push and hold the bottom half of the rocker switch. Make sure the step is
completely extended and locked in position before releasing the switch.
2. Push and hold the top of the rocker switch to retract the step. Make sure the step is completely
retracted and locked in position before releasing the switch.
NOTE: The extend/retract function will be reversed if the red and yellow terminal connections are reversed
or the step is equipped with a reverse-driven motor assembly (such as on the 37 and 42 Series Steps).