KwiKool KPO12 - Alarm Codes List

KWIKOOL KPO PORTABLE AIR CONDITIONERS
20
USER PARAMETER LIST
Select ON/OFF to exit or after 1 minute the display will default back to the operating screen.
P30- Beeper enable
Select 0 or 1
0- Disable, 1-
enable
P40-Filter counter
Hours/10- 0 thru 999
Read Only
P41-Filter counter reset
Select 1 to reset
Defaults back to 0
P42-Filter Alarm Delay
Days, select 0 thru
180
0- Disable
P84-Supply Air Value (T3 dis-
play)
F or C
Read Only
P100-Enable Dimming
Select 0 or 1
0-Disable, 1 Enable
P101-Dimming time
Min, Select 0 through
10
Defaults to 5
P102-Dimming brightness
% 1,5,10 through 90
Defaults to 10
P105-Brightness in active state
% 50 through 100
Defaults to 100
P201-Displays microprocessor
board version
N/A
N/A
SECTION XI - ALARM CODES LIST
ALARM CODES LIST
A1
Customer installed input
Optional, Normally Closed
A2
Customer installed input
Optional, Normally Open
CP
Condensate pump fault
Standard
LP
Low Freon level detected
Standard
HP
High Pressure detected
Standard
FD
VFD Fault
Standard
PH
Incoming Power Fault
Standard
FL
Run time for filter elapsed
Standard
FS
Freezing detected
Optional
DC
Deicer in cool
Optional