Please read this booklet as it
contains important information about
the correct installation and opetation
of the Kwikboil unit. Failure to install
the Kwikboil correctly will deem the
Product Warranty null and void
IMPORTANT NOTES
1.
1.1
1.3
Please ensure that the mains cold
water supply is connected to the
indicated water inlet connection of the
Kwikboil (at the base of the solenoid
valve) and that the unit vent connection
always has a free flow of air into and
out of the boiling water chamber.
1.4
The Kwikboil is a simple techn-
ologically advanced electronic
automatic boiling water system and
operates differently and more
efficiently to other mechanical systems.
Please familiarise yourself with the
filling and operating modes of this
electronic system as explained on
Page 4 and 5 of the Manual.
2
1.6
The Kwikboil unit produces boiling
water and care should be taken at all
times when using it.
WATER QUALITY
Caution is suggested if the Boiling Water
Unit is to be connected to a water supply
with.a high content of silica of calcium.
Water supplies of this nature may be
detrimental to the unit's operation and may
cause the warranty to become void. For
further information relating to the guidelines
of water quality, contact your local service
agent for advice.
3
INSTALLATION
This Boiling Water Unit shall be installed by
a qualified service person. The installation
must comply with the local building
regulations and the relevant wiring and
plumbing regulations.
3.1
LOCATION
This unit is designed for interior installation
only and is NOT WEATHERPROOF. If the
unit is to be installed outside, it must be
protected from the weather and from
freezing.
Page 01
CONTENTS
Page 02
1.2
The Kwikboil is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction.
Concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to
ensure that they do not play with the
appliance.
The kwikboil is designed and
manufactured to operate at a maximum
incoming mains cold water pressure of
1000kPa.Should the water pressure
exceed 1000 kPa, an inline pressure
reducing valve must be fitted.
1.5
The Kwikboil system facilitates a
boiling water temperature adjustment
for different altitude installations. A
temperature trim pot is located in the
electronic controller (PCB) Should a
temperature adjustment be necessary,
the procedure is detailed on Page 10 of
the Manual.
1.7
Instructions are also available on the
internet and via website
www.kwikot.com
To Next Page
Loading...