PP
RD
FL
SL
HT
HL
LL
E L ELE N
Fault 4: "FAULTY OPEN CIRCUIT THERMISTOR"
This fault will occur when the thermistor is faulty
and not detecting the tempreture of the water.
This fault will be indicated on the PC-board by
flashing the "FL" LED and by flashing the "READY"
LED on the front face plate as follows eg.
This fault can be corrected by checking for a loose
connection or replacing the thermistor. The unit will
remove itself out of this fault mode once normal
operation has been restored.
DIAGRAM:DIMENSION SPECIFICATION
2.5;5;7.5;10;15L MODELS
4.5
C
D
B
L
N
F
E
G
A1
R
S
P
K
I
H
M
A
VENT
POWER CABLE
INLET
J
SIDE VIEW
DIMENSION SPECIF ICATION
FOR 2.5L, 5L, 7.5L AND 10L 15L KWIKBOIL
13
8
10
DETAIL A1
ENLARGED MOUNT ING HOLE
Page 07 Page 08
To Next Page
Loading...