21
Programming Notes
Enable/Disable User Codes:
When all User Codes are disabled, all electronic functions will be disabled as
well. The door must be locked or unlocked manually with the key. Repeat the
programming steps to enable the User Codes.
Add One-Time Use Code:
Up to 10 One-time User Codes can be saved. One-time User Codes should be 4 to
8 digits in length. The One-Time User Code will be deleted automatically after it is
used. The same One-Time User Code can be created again after it’s used.
Change Auto-Lock Time Delay:
Press the keypad number that corresponds to your time delay preference:
“1”: 30 seconds “2”: 1 minute “3”: 3 minutes “4”: 5 minutes “5”: 10 minutes
Enable/Disable AutoLock:
The default setting is disabled. Once you enable auto-lock the default setting is
set to 30 seconds.
To change the auto lock time delay, see the “Change Auto-Lock Time Delay”
programming step.
Repeat the programming steps to disable auto-lock.
Door Rehanding Identification:
Perform this process for the lock to learn the locking and unlocking direction of
the door.
This feature is used for the lock to learn the orientation of your door (left- or right-
handed). If stuck/jammed bolt error continues to occur after performing this
step, please make sure there is no obstruction from strike or door jamb to prevent
the bolt from extending.
Factory Reset:
A factory reset will delete all User Codes and change all programming to factory
settings.
To Next Page
Loading...
Need help?
General
