KWS MS-12A - Troubleshooting Guide; Resolving Machine Startup and Operation Faults

17
TROUBLESHOOTING GUIDE
Issue Cause Solution
Machine does not start Slicer not plugged in Plug in slicer
Lack of power from the
electrical network
Restore the supply of
power from the electrical
network
Machine’s On-Off switch is
in “o” position
Push the green button to
“I” position
Damaged On-Off switch Contact dealer or
KitchenWare Station
customer service team to
have the damaged part
replaced
Machine starts but blade
does not spin
Blade is in contact with
blade guard ring
Contact dealer or
KitchenWare Station
customer service team for
assistance
Machine does not stop Damaged On-Off switch Contact dealer or
KitchenWare Station
customer service team to
have the damaged part
replaced
Damaged motor Contact dealer or
KitchenWare Station
customer service team to
have the damaged part
replaced
Machine shut down
suddenly
Motor overheated Turn the machine off and
let the machine rest and
cool down
Insufficient power supply Make sure to have enough
amps to support the
machine
Machine trips the breaker Insufficient power supply Make sure to have enough
amps to support the
machine