Kygo E7/900 - True Wireless Pairing

ENGLISH
14
Method 1: Pick up the two headsets from the charging base to power on and wait
for 10 seconds. The two headsets will now enter auto-pairing mode and connect
with each other after a few seconds. The headset (R) will blink red and blue and
prompt “pairing”. Then open the device’s Bluetooth congurations and select
“KYGO E7/900 – R”.
Method 2: On OFF state, press both MFB buttons for 2 seconds to power on and
wait for 10 seconds. The two headsets will now enter auto-pairing mode and
connect with each other after a few seconds. The headset (R) will blink red and
blue and prompt “pairing”. Then open the device’s Bluetooth congurations and
select “KYGO E7/900 – R”.
After the headset is successfully paired through method 1 or 2, the right headset
prompts “pairing successful – device connected”.
True Wireless Pairing