1. GENERAL INFORMATION
1-8
Protect wires and harnesses with electrical tape or
tube if they contact a sharp edge or corner.
When rubber protecting cover is used to protect
the wire harnesses, it shall be installed securely.
Do not break the sheath of wire.
If a wire or harness is with a broken sheath, repair
by wrapping it with protective tape or replace it.
When installing other parts, do not press or
squeeze the wires.
Do not press or
s
ueeze the wire.
Do not pull
too ti
ht!
After routing, check that the wire harnesses are
not twisted or kinked.
To Next Page
Loading...
