KC170
7.
Place the carburetor into the intake pipe being
careful to align the lug on the carburetor with the
alignment tabs ou the air intake pipe; then tighten
the clamp sec
ur
ely.
8. Install the
air filter housing onto
th
e frame: then
connect
th
e inlet air duct. air silencer duct. and
intake housing
to
Throttle Body and tighten all
hose clamps secu
rel
y.
3-46
9.
In
stall
the
shift rod onto the shift arm with bushing
and flat washer and secure with an
E-clip; then
connect the sp
ee
dometer sensor plug.
To Next Page
