KYMCO PEOPLE 150 User Manual

12. FRONT WHEEL/FRONT BRAKE/
FRONT SUSPENSION
12-12
PEOPL E 12 5/150
Remove the pistons from the brake caliper.
If necessary, use compressed air to squeeze
out the pistons through the brake fluid inlet
opening and place a shop towel under the
caliper to avoid contamination caused by the
removed pistons.
Check each piston cylinder for scratches or
wear and replace if necessary.
Push the piston oil seals outward to remove
them.
Clean each oil seal groove with brake fluid.
Check each piston for scratches or wear.
Measure each piston O.D. with a micrometer
gauge.
Service Limit: 33.90mm
Check each caliper cylinder for scratches or
wear and measure the cylinder bore.
Service Limit: 33.45mm
Compressed Air
Piston Oil Seals
Be careful not to damage the piston
surface.
＊
www.PlanDeGraissage.org

KYMCO PEOPLE 150 Specifications

General

Ignition	CDI
Front Suspension	Telescopic Fork
Front Brake	Disc
Rear Brake	Drum
Fuel Capacity	7.5 Liters
Wheelbase	1380 mm
Cooling System	Air Cooled
Starter	Electric
Transmission	CVT