27
OPERATION
Steering inspection
Before each ride, inspect the handlebars and steering on your
motorcycle.
1. Visually inspect the handlebars for damage.
2. Grasp the front brake and push the suspension up and
down, listening for any abnormal noise.
3. Move the handlebar upwards, downwards, and to left and
right to check for any loose or restricted movement.
4. Make sure that the steering moves freely through its full
range of motion from full left to full right.
Proper handlebar, steering component, and front sus-
pension action is essential for your riding safety. Con-
tact your KYMCO dealer immediately if you have any
steering or suspension-related service needs.
Lights & horn inspection
Before each ride, check the light and horn operation on your mo-
torcycle.
Headlight/taillight inspection
Start the engine to make sure the headlights 5 and the
taillight 7 illuminate. Check the lens for damage, dirt or
moisture condensation.
Turnsignal inspection
Operate the turn signal rocker switch on the left handlebar
controls to make sure that both the left and right turn sig-
nals 6 illuminate and flash. Check the lens for damage,
dirt or moisture condensation.
Stoplight inspection
Squeeze the front brake lever, and then press down on the
rear brake lever to make sure the stoplight in the taillight
7 illuminates.
55
55
5
66
66
6
77
77
7
To Next Page
Loading...
Need help?
General
