Kyocera ECOSYS M3645dn - Group Auth. (Group Authorization Settings)

9-17
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
Group Auth. (Group Authorization Settings)
Set restrictions of the machine usage by each individual group registered in the authentication server.
Group Authorization
Use the group authorization.
1
Display the screen.
1 [System Menu/Counter] key > [▲] [▼] key > [User/Job Account] > [OK] key
2 [▲] [▼] key > [User Login Set.] > [OK] key
2
Configure the setting.
[▲] [▼] key > [Group Auth.] > [OK] key > [▲] [▼] key > [Off] or [On] > [OK] key
NOTE
• To use the group authorization settings, [Netwk Authentic.] must be selected for the authentication method in
"Enabling User Login Administration". Select "On" for "LDAP" in "Protocol Settings".
Enabling User Login Administration (page 9-3)
ProtocolSettings (page 8-12)
• Setting to use group authorization is performed from the operation panel. The groups should be registered with
Command Center RX.
Command Center RX User Guide
NOTE
If the login user name entry screen appears during operations, enter a login user name
and password, and select [Login]. For this, you need to login with administrator
privileges.
The factory default login user name and login password are set as shown below.
Login User Name: 4500
Login Password: 4500