Kyocera ECOSYS P2040dn

6-14
Setup and Registration (System Menu) > System Menu
SNMP Select whether to communicate using SNMP.
*2
Value: Off, On
Wi-Fi Direct
*1
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [SNMP] is set to [On].
Wi-Fi
*1
Wired Network
SMTP Select whether to send E-mail using SMTP.
Value: Off, On
POP3 Select whether to receive E-mail using POP3.
Value: Off, On
RAW_Port Select whether to receive documents using Raw Port.
*2
Value: Off, On
Wi-Fi Direct
*1
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [RAW_Port] is set to [On].
Wi-Fi
*1
Wired Network
LPD Selects whether to receive documents using LPD.
*2
Value: Off, On
Wi-Fi Direct
*1
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [LPD] is set to [On].
Wi-Fi
*1
Wired Network
IPP Selects whether to receive documents using IPP. To use the IPP protocol, select [Not Secure
(IPP&IPPS)] on IPP Security under Security Settings from the Command Center RX.
*2, *3
Value: Off, On
Wi-Fi Direct
*1
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [IPP] is set to [On].
Wi-Fi
*1
Wired Network
IPP over SSL Select whether or not to use IPP over SSL.
*2, *3
Value: Off, On
NOTE
When selecting [On], it also requires a certificate for SSL. the default certificate is the
self-certificate of the machine.
Command Center RX User Guide
Wi-Fi Direct
*1
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [IPP over SSL] is set to [On].
Wi-Fi
*1
Wired Network
Item Description