EasyManuals Logo

Kyocera ECOSYS P6030cdn User Manual

Kyocera ECOSYS P6030cdn
227 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
Troubleshooting 5-7
Device busy
This message is displayed when Remove Device was selected while a USB memory
was being used.
The previous screen is displayed again 1 or 2 seconds.
Duplex disabled
Press GO
You attempted to print with a paper size and paper type that cannot be used for duplex
printing. Press [GO] to print onto one-side of the paper only.
Enter Account
An account code must be entered. This message is displayed if you try to print from the
operation panel (e.g. printing a status page or using the Job Retention function) when
the Job Accounting function is enabled. For more information, refer to Job Accounting
(Job Accounting selection/setting) section of the Advanced Operation Guide.
Envelope mode
Displayed when the envelope switch is set to envelope mode.
Error.Power off.
F###
Turn the power switch off and then back on again. If this message still remains, turn the
power switch off, and contact your service representative or authorized service center.
Error.Power off.
F000
The printer controller and operation panel cannot exchange data. Turn the printer off
and unplug it from the mains power supply. Then contact your service representative or
authorized service center. See the back page of this manual for the relevant phone
numbers.
Exceeded Max.output
Press GO
This message is displayed when the Job Accounting function is enabled and an
attempt has been made to exceed the print limit set for each account. To return the
printer to the print-ready status, press [GO].
For more information, refer to Job Accounting (Job Accounting selection/setting)
section of the Advanced Operation Guide.
Format SSD.
The SSD installed in the printer is not formatted, and therefore cannot be read or
written.
ID error
The user ID entered for a private job, or a stored job is not correct. Check the user ID
that you specified on the printer driver. For more information, refer to Job Box section
of the Advanced Operation Guide.
Illegal Account
Press GO
This message is displayed when the Job Accounting function is enabled and no
account is set for a transmitted print job or the specified account is not registered (the
incorrect account is set). To return the printer to the print-ready status, press [GO].
For more information, refer to Job Accounting (Job Accounting selection/setting)
section of the Advanced Operation Guide.
Job not stored
Press GO
Printing using the Job Box function failed because there was insufficient space
available on the hard disk or RAM disk, or because the RAM disk was disabled when
demounting the hard disk. To print an error report and return the printer to the print-
ready status, press [GO].
Job restricted
Press GO
This message is displayed when printing was attempted, despite the Job Account
function being on with Restriction applied as the job limit for each job account.
To return the printer to the print-ready status, press [GO].
For more information, refer to Job Accounting (Job Accounting selection/setting)
section of the Advanced Operation Guide.
Message Corrective Action

Table of Contents

Other manuals for Kyocera ECOSYS P6030cdn

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera ECOSYS P6030cdn and is the answer not in the manual?

Kyocera ECOSYS P6030cdn Specifications

General IconGeneral
ColorYes
Print technologyLaser
Maximum resolution600 x 600 DPI
Duplex printing modeAuto
Time to first page (black, normal)8.5 s
Print speed (black, normal quality, A4/US Letter)30 ppm
Printing colorsBlack, Cyan, Magenta, Yellow
Maximum duty cycle100000 pages per month
Number of print cartridges4
Page description languagesMicrosoft XPS, PCL 5c, PCL 6, PCL XL, PDF 1.7, PostScript 3
Paper input typeCassette, Paper tray
Total input capacity650 sheets
Total output capacity- sheets
Maximum input capacity2150 sheets
Total number of input trays2
Maximum number of input trays5
Multi-Purpose tray input capacity150 sheets
Custom media width70 - 216 mm
Maximum print size216 x 356 mm
Custom media length138 - 356 mm
Paper tray media typesPlain paper
Paper tray media weight60 - 120 g/m²
Non-ISO print media sizesFolio (media size), Letter (media size)
ISO A-series sizes (A0...A9)A4, A5, A6
ISO B-series sizes (B0...B9)B5
Maximum ISO A-series paper sizeA4
Multi-Purpose Tray media weight60 - 220 g/m²
Wi-FiNo
Mobile printing technologies-
Standard interfacesEthernet, USB 2.0
Optional connectivityWireless LAN
Processor model465S
Processor familyPowerPC
Maximum internal memory1536 MB
Sound power level (standby)34.4 dB
Sound pressure level (printing)52.5 dB
DisplayLCD
CertificationTÜV/GS, CE
Product colorBlack, White
Display number of lines2 lines
AC input voltage220 - 240 V
AC input frequency50 - 60 Hz
Power consumption (off)0 W
Power consumption (standby)76 W
Power consumption (printing)529 W
Power consumption (PowerSave)4 W
Mac operating systems supportedMac OS X 10.5 Leopard, Mac OS X 10.6 Snow Leopard, Mac OS X 10.7 Lion, Mac OS X 10.8 Mountain Lion, Mac OS X 10.9 Mavericks
Sustainability certificatesBlue Angel, ENERGY STAR
Weight and Dimensions IconWeight and Dimensions
Depth518 mm
Width345 mm
Height480 mm

Related product manuals