2HJ/2JK
1-3-18
1-3-2 Maintenance
(1) Method of removing the toner soiling which comes in contact with heat roller and press roller/press belt
When misfeeding has occurred in the fuser unit, misfeed paper can coil around the heat roller or the press roller/press
belt.
Removing the misfed paper will cause, there are times when the toner soiling remains in the heat roller or the press roller/
press belt). Follow the procedure below in this case and remove the toner soiling from the heat roller or the press roller/
press belt.
1. Remove the misfed paper. Cancel misfeed by opening and closing a cover. wait until the message display shows
[Ready].
2. Press MENU key and set paper type to [Transparency] and paper source to [MP tray].
3. Set the a sheet (transparency sheet [3M CG3700] or thick paper with the of more than weight above 135 g/m
2
) to
MP tray.
4. Press MENU key and print a status page. (The toner soiling which comes in contact with the heat roller and the
press roller/belt will be transferred onto paper).
5. Until the toner soiling is cleared, repeat (Usually when 4 - 5 it prints, the soiling goes out) the above procedure.
To Next Page
Loading...
