Kyocera M2535dn - Page 368

8-160
Default Setting (System Menu)
5 Press the  or  key to select [Secure Protocol].
6 Press the OK key. Secure Protocol appears.
7 Press the  or  key to select [LDAP Security].
8 Press the OK key. LDAP Security appears.
9 Press the  or  key to select [Off], [SSL/TLS] or
[STARTTLS].
10 Press the OK key. Completed. is displayed and the
screen returns to the Secure Protocol menu.
SMTP Security
Select the communication protocol according to the type of security employed by the SMTP server. The default setting
is
Off .
NOTE: SMTP (E-mail TX) must be set to On in Protocol Detail on page 8-151.
The table below shows the available settings.
* You can change the port number using Command Center RX.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the  or  key to
select [System/Network], and press the
OK key.
Secure Protocol: a b
2 IPP Security
3 HTTP Security
*********************
[ Exit ]
4 LDAP Security
LDAP Security: a b
*********************
2 SSL/TLS
3 STARTTLS
1 *Off
Item Description
Off Do not use security employed by the SMTP server.
SSL/TLS Encryption is applied any data communication. To enable SMTP security, the
SMTP port may have to be changed according to the server settings.
Typically, 465* for SSL/TLS is well-known SMTP port.
STARTTLS Encryption is applied any data communication. Typically, 25* or 587* for
STARTTLS is well-known SMTP port.
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System/Network