(Page.3/4)
Service Bulletin Ref. No. 2T6-0019 (J010)
<Date> January 25, 2019
KYOCERA Document Solutions Inc.
For authorized KYOCERA engineers only.
Do not distribute to non-authorized parties.
(3) After confirming the display [FW-Update Completed] (after firmware update is completed), confirm
ENGINEfirmware version is new and [2T6_1000.002.006].
(4) Turn the power switch off, disconnect the power cord and remove the USB drive.
(5) Turn the power on and confrim the main unit drives for about 30 seconds and stops to start up normally.
3. Field machine 2 (Main unit where the phenomenon of “The waste toner box is not properly installed.” display
not disappearing)
(1) Insert a USB drive with the new firmware into the USB host interface slot while the power cord is
disconnected. Connect the power cord to the outlet.
(2) Turn the power on ⇒ Firmware update is executed for about 1 minute.
(3) After confirming the display [FW-Update Completed] (after firmware update is completed), confirm
ENGINEfirmware version is new and [2T6_1000.002.006].
(4) Turn the power switch off, disconnect the power cord and remove the USB drive.
(5) Turn the power switch on .⇒ The main unit is only driven with the display of [Please wait, installing
toner] for about 4 minutes.
(Refer to topic 1-B) in the page 1)
*This toner filling operation can be cancelled by pressing [OK] at [Menu] ⇒09 Adjustment/maintenance ⇒
03 Service Settings ⇒06 Toner Install.
(6) Turn the power off when drive stops.
(7) Turn the power on and confrim the main unit drives for about 30 seconds and stops to start up normally.
To Next Page